How do I use a water activated tape dispenser?

Using a water activated tape dispenser is a simple process, but there are a few steps you should follow to ensure that the tape is applied correctly.

  1. Fill the dispenser with water: The dispenser has a water reservoir that needs to be filled before use. Check the marker on the side for the correct water level.

  2. Load the tape roll: Insert the roll of water activated tape into the dispenser, making sure that the tape is fed through the guides and rollers.

  3. Cut the tape: When the tape is in the desired position, use the built-in cutter on the dispenser to cut the tape to the desired length.

  4. Apply the tape: Place the tape along the surface you want to seal. Press the tape down firmly to ensure that it adheres properly.

  5. Clean the dispenser: After use, be sure to clean the dispenser by emptying the water reservoir, wiping down the rollers and guides, and removing any excess tape. This will ensure that the dispenser is ready for the next use.


Leave a comment

Please note, comments must be approved before they are published

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


You may also like

View all
Example blog post
Example blog post
Example blog post